Hi there!
Change the BDI-2000 subnet mask to 255.255.255.0. Make sure your
RedHat 8.0 host also uses same subnet mask. Delete the entry for
gatweay, it is not needed. BDI does not support ping. However, if you
can see arp request-replies, all is well. Fix your subnet mask.
Hummm... changing the submask doesn't work... about the gateway, I
did'n't find a way to delete it. Anyway, they are on the same subnet!
I wonder whenever my firmware is broken 8) By the way, does anybody has
a working 1.15 firmware?
Thanks,
Xisto
quoted
I'm new to bdiGDB and I'm facing some problems with it. I've got a
bdiGDB for a 82xx PPC and I've correctly updated its firmware and
configured it through the RS232 interface, specifying its IP address,
my host IP, bla bla bla. But when I try to communicate through the
ethernet, by a telnet section, it doesn't seem to respond at all.
Some facts:
- Target MPC8260 in a MPC8260ADS board;
- RedHat Linux 8.0 as the host;
- dump from the bdi200 setup:
BDI Type : BDI2000 Rev.C (SN: xxx)
Loader : V1.05
Firmware : V1.15 bdiGDB for PPC6xx/PPC7xx
Logic : V1.02 PPC6xx/PPC7xx
MAC : 00-0c-01-xx-xx-xx
IP Addr : 192.168.0.2
Subnet : 255.255.255.255
Gateway : 255.255.255.255
Host IP : 192.168.0.1
Config : mpc820ads.cnf
- The 'load mode' was correctly closed;
- The ethernet 'link' led is on and the 'rx' led blinks as packets
ares sent on the net;
- The bdi doesn't even answer my pings!
- Sniffering the net, I've seen several ARP request and replies,
exchanged by bdi->host and host->bdi.
Some questions:
- Do I need to have my target conected to bdi in order to
stabilish the telnet connection?
- What about the tftp server, does it have to be running at
this point?
- What services are provided by the bdi? Telnet on TCP port 23?
ICMP also? And what about the debugger, does it listen to
port 2001?
- How can I get it running?
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/