Re: MCR question

this runs an address pattern from the UPM table on the address bus.
from the location you set-up the location that terminates in the upm table

You have to write this pattern into the UPM table.

It is normally used to set-up the SDRAM for the 860 as it does not have a
SDRAM controller by default.

So things like the control word for the SDRAM chip have to be written to the
chip via the address bus i.e .. for CAS latency, interleaving etc.

Hope this help

Its really quite clever .. but very confusing

Frank

----- Original Message -----
From: "Laudney Ren" <redacted>
To: "linuxppc-embedded" <redacted>
Sent: Saturday, January 18, 2003 8:34 AM
Subject: MCR question

Hi, all:

  From MPC860 User Manual, MCR has a field named "OP". when its value is
10, the operation is "RUN". The description for "RUN" in the manual is:

"... the AMX bits of the UPM RAM word in this software initiatede
pattern must all be set to 0b11. Thus, the address for this pattern is
the value written to MAR. The data bus is not driven."

My question is, what does the "pattern" mean? What's its use? What is
the "address for the pattern"? Is this address a RAM address and the
pattern will be read from this location? What is MAR for?

Thanks.

Laudney Ren

--
An expert is one who knows more and more about less and less
until he knows absolutely everything about nothing.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/