In message [ref] you wrote:

I downloaded both the ramdisks. I would appreciate, if
you can tell me what should i have as the value for
"root=", in Kernel Command Line. Mine shows as
"Linux/PPC load: console=ttyS0,19200 console=tty1
ip=off root=/dev/part rw".

root=/dev/ram rw console=ttyS0,19200 ip=off

should be what you need.

And also, if i select the baud rate 19200, do i have
to change anything in the linux code other than
initial configuration file (defconfig).

You don't have to change anything in  the  kernel.  The  baudrate  is
passed by the boot loader.

Best regards,

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
Veni, Vidi, VISA:
        I came, I saw, I did a little shopping.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/