to see where your boot code starts:

at the BDI prompt the command:
reset halt  <enter>
followed by the command
info  <enter>

BDI responds with:

    Target state      : debug mode
    Debug entry cause : debug port nonm
    maskable breakpoint
   Current PC        : 0xfff00100

current pc is where your boot code starts
hope this helps
pat

----- Original Message -----
From: "Wolfgang Denk" <redacted>
Sent: Friday, December 20, 2002 1:09 PM
Subject: Re: use bdi on board with ppcbug

In message [ref] you wrote:

quoted

Wouldn't it be the PowerPC reset address - 0xFFF00100?

0xFFF00100 is just one out of several possibilities, depending on CPU
type and system configuration.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/