Fw: HHL 2.1 preview kit

Thanks for the answer, I have got the image.

Unfortunately the Image doesn' t run. The problem is derived from the
loading the image file.
The boot loader is PPCboot 1.0.5 and the "vmlinux.gz" has been converted
with the "mkimage" utility. The bootloader is able to download the image
generated with the CDK 1.2 (kernel 2.4.0-test2) but when it downloads the
image which is the result of new compilation (HHL 2.1), program is stuck
after the decompression.

Anybody has some suggestions to give me?


Thanks
Gianfranco

----- Original Message -----
From: "Yu Bo-BOYU1" <redacted>
To: "'Ing.Gianfranco Morandi'" <redacted>;
"LinuxPPC" [off-list ref]
Sent: Thursday, October 03, 2002 4:20 PM
Subject: RE: HHL 2.1 preview kit

you need to change some definitions in makefile

ARCH := ppc
CROSS_COMPILE = ppc_82xx-

Bo

-----Original Message-----
From: Ing.Gianfranco Morandi [mailto:gianfranco.morandi@euro-studio.it]
Sent: Thursday, October 03, 2002 9:11 AM
To: LinuxPPC
Subject: HHL 2.1 preview kit



Hi to all,

I have a question regarding the preview kit of Montavista.

I have downloaded the CD Image and installed the tools for the Sandpoint
8240 (which should be an 82xx architecture).

When I try to configure the kernel with "make config" command, no

processor

other than x86 can be selected.
In other word I cannot select the Power PC architecture.

I would like to install the kit for the EST8260 board and I thought that
such installation was a good base to start.

Anybody has suggestions to give me?

Any help is appreciated.

Gianfranco

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/