Re: Can't disassemble my device driver

Tom Stefanski wrote:

I have a adatron bdi 2000 connected to my target board and have
successfully load the linux kernel and set breakpoint in schedule
However when I load my device driver, it's text section is a 0xD11D6060
and the kernel is a 0xC00xxxxx. When is disassemble any routine in my
driver, I get all zeros.

 I have MMU xlate set in the config file and I program the mmu correctly
since I can break a schedule. Any help would be apprecciated


 Tom

Did you remember to specify the text address when you added the symbol file in
gdb?  If you didn't type 'help add-symbol-file' in gdb and it will explain where
you can specify the starting text address of your device driver module.
Neil
--
/******************************************************************
*Neil Horman
*Software Engineer
*LVL7 Systems
*13000 Weston Pkwy.
*Cary, NC 27513
*(919)-865-2915
*nhorman@lvl7.com
*PGP keyID 0xB5E1020A
*http://www.keyserver.net/en
*******************************************************************/


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/