Re: LXT972 FEC problem on MPC855

quoted

eth0: config: auto-negotiation on, 100FDX, 100HDX, 10FDX, 10HDX.
IP-Config: Incomplete network configuration information.

You are passing bad/insufficient boot arguments to the Linux  kernel;
unfortunaltely you don;t show us this part of the boot messages, so I
cannot even guess what you're doing wrong.

Well, if IP-Config is not complete, we can change the configuration
using 'ifconfig' after the kernel starts. I did that. And I noticed that
'eth0' can receive packets but cannot transmit any packets. Here is the
result of running ifconfig.

---------------------------once----------------------------------
#ifconfig
eth0      Link encap:Ethernet  HWaddr 00:06:17:01:02:00
          inet addr:192.168.5.24  Bcast:192.168.5.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:180 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:18110 (17.6 kb)  TX bytes:0 (0.0 b)
          Base address:0xe00
---------------------------once----------------------------------
---------------------------twice---------------------------------
#ifconfig
eth0      Link encap:Ethernet  HWaddr 00:06:17:01:02:00
          inet addr:192.168.5.24  Bcast:192.168.5.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:282 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:26831 (26.2 kb)  TX bytes:0 (0.0 b)
          Base address:0xe00
---------------------------twice---------------------------------

- Shawn.


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/