Re: linux booting

In message [ref] you wrote:

When I "bootm 0x10000"in ppcboot,it runs to
"Transferring control to linux kernel",then hangs
there,and I see nothing in the console.:(

This will never work. I bet it  didn't  work  with  your  old  kernel
either.  0x10000  is  just  64  kB  -  this  is _never_ enough for an
uncompressed Linux kernel.  You  will  overwrite  your  kernel  while
uncompressing it, which crashes the system. Use a higher load address, somthing like 0x200000.

In the PPCBoot guide(FAQ section),it mentioned
2 possible causes,wrong bdinfo and clocks_in_mhz
I do check it and feel nothing wrong,however
nothing yet.

You have to _unset_ clocks_in_mhz for a 2.4.20-pre2 kernel.

I have a BDI2000,but I think I should debug the bootm
part of ppcboot,however someone says it is quite
difficult to do so( at least for me).

Well, it's not _that_ difficult. Try it out, so you get used to is ;-)

so I am seeking errors in blind.

Just open your eyes, and thou shalt see :-)

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
Always leave room to add an explanation if it doesn't work out.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/