Re: new G4 dual 1 gig is here - how to install?

Hi,

I hooked up an 17inch CRT and the DFP flat panel to the ATI 7500.

Then I tried booting linux, here are some excerpts from the dmesg log
(hand typed)

radeonfb: ref_clk = 2700, ref_div = 12, xclk = 20025 from OF

ATI Radeon 7500 QW DDR SGRAM 32MB

radeonfb:  DVI port no monitor connected
                   CRT port no monitor connected

So it looks like it can't detect which port to use and defaults to CRT?

I will just hack the driver to force use of DVI and try to work around
this issue so that I don't need 2 monitors connected.

But Here is the interesting line that I can't figure out

no framebuffer address found for
/pci@f0000000/ATY,BlueStoneParent@10,ATY,BlueStone_B

That's just the second head, your card is dual head message
is normal.

So it looks like there is some other ATI device in the system that I
don't understand where or what it is.  I see both entries for this
BlueStone thing and entries for the Radeon 7500 in the device tree.

Also, interestingly enough, SOUND is out of control on this new
machine.  A beep comes out at ear-shattering levels no matter what I
do.  I do believe something has changed when it comes ot sound in these
new systems.

Maybe yet another crappy tumbler setup ? Make sure you use my
latest kernel, I also started adding some 7455 support & cleaned
up the NAP/DOZE/idle thing.

Ben.


** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/