Re: MPC8240 EPIC Driver (Attached)

James F Dougherty wrote:

A while ago, I posted some questions on getting the OpenPIC driver working
correctly for the EPIC (Embedded Programmable Interrupt Controller) internal
to the MPC8240. After several attempts on open_pic.*, I gave up, and ported a
an existing driver.

Ummm, I'm confused.  The existing PowerPC OpenPIC works just fine with
the 8240/8245/MPC107 EPICs, at least on the Sandpoint.  I can't believe
there would be much of anything needed for a custom board.  I have some
Sandpoint X3 patches that enables the serial mode control lines as well.
I think there could be a few minor improvements, but it is certainly
functional.  All you should need are the interrupt senses table for
the OpenPIC initialization and the proper routing table for the PCI
setup.


	-- Dan

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/