Re: Fwd: mesh SCSI bus locks hard on 7500 when burning a CD-R in dao mode

On Sat, Jan 27, 2001 at 02:57:58PM -0500, Daniel Eisenbud [off-list ref] wrote:

On Sat, Jan 27, 2001 at 12:39:31PM +0100, Benjamin Herrenschmidt [off-list ref] wrote:

quoted

Do you get the same lockup without the G3 accelerator ?

Good question.  I got the CD-RW and the accelerator at the same time,
so I actually have no idea.  About six months ago when I made a brief
attempt to look into this problem, I found another report of the same
thing, which I don't think mentioned an accelerator.  I'll have to try
to figure out where I saw that.  In any case, I can swap in the old CPU
this weekend and see if it works.  I'll report back when I have more
information.

I just tried this without the G3, and the exact same thing happens.  I
also did "dmesg -n 8" on the console where I tried to run cdrdao, before
burning the CD, but got no additional output.  I'll try this again both
with cdrecord (which had the same failure mode the last time I was
trying to solve this problem) and with syslog logging only to the
console.  If those don't work, I guess the next step is probably to see
if I can see anything over a serial console, and maybe to install
another copy of the OS on the external hard disk and boot from there,
and see if that lets me get more information?

-Daniel

--
Daniel E. Eisenbud
eisenbud@cs.swarthmore.edu

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/