Re: your mail

On Thu, 13 Jul 2000, Crusman wrote:

quoted

The configurations I have are for 2600 with a PMC graphics board, remove
CONFIG_VT from the setup and it will use a serial console.

BTW use PrePboot for these boards (CONFIG_PREPBOOT) since it gives a nicer
PCI layout to access the VMEbus...

Please use the patches mvme2600.*.bz2...

I have tested the patches but the new kernel don't see the scsi device...so
I can't try it anyway !

Did you try the nfsroot (or nfsinstall but it's probably broken now) ? The
nfsroot does not have any CONFIG_VT set so it should work. At least it
works on headless 2600 and 2400.

Yes, I have tested your kernel, but there is a message ( PC keyb error... or
something like this) wich lock the kernel during the boot ! It's probably
due to the Virtual Terminal support in the kernel !
I always use the "console=ttyS0,9600" kernel option.

Then it should not do this, I don't know what happens. AFAIR it works on
MVME2400 whcih don't have the KB controller either.

In short :

- I can't use your kernel because of the PC_key error !
- I can't patch & build a new kernel because this new kernel don't see my
SCSI PMC !

Did you ever see the PMC module with some kernel ? Once booted (an nfsrrot
system is the best for this), see what you have in /proc/bus/pci.

	Gabriel.

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/