Re: Stealth port problems

Sun, Jul 30, 2000,   Giuliano Pochini wrote:

Giuliano Pochini wrote:

quoted

quoted

quoted

Hi!  I have troubles with my stealth port on a G3-blue. When it runs at

115200

quoted

ifconfig
shows a lot of overruns. At 57600 it works fine, but it's slow :-((

The problem is definitely X.  I made a lot of tests: with dma and non-dma
serial driver, X accelerated, non accelerated, X bare.bone (started with
xinit). The problem is X. When X is running the serial ports looses packets
:-((
Am I the only one who is having this problem ???  Why does X cause overruns ??

If you can try 2.2.17pre10ben2 or pre13ben2 (linuxcare linux-pmac-benh) then
you can apply the IRQ latency test and see if it is that which is blocking
you.  Scan the dev list for "[ANN} IRQ".

It is possible (there was a discussion in the ANN thread about fb IRQ
blocks) - X may aggravate this.

I have seen 2ms of IRQ blocking on the Lombard (using IDE CDROM) and around
450-750 us of IRQ blocking on my other machines (SCSI). [when heavily
loaded].

The RX buffer in an 85230 (which is actually the chip - IIRC - an enhanced
8530) is 8 characters deep - so any more that about 700 us IRQ block will
cause a drop out at 115200 continuous...

So it looks like music might not be the only pressure to tune the IRQ
latencies :-)

Note that an x86 kernel guru said on the lad list "a well tuned kernel
should not exhibit more than about 60 us worst-case IRQ block"

we have a ways to go to get to that.

Iain.

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/