Re: My (per)version of 8xxrom

In message [off-list ref] you wrote:

I am using 8xxrom on one of our modem boards, to start Linux.
I have made several little changes which seemed to be required.

Well, IMHO this code needs more than just a few little changes :-(

Some of the changes are to support this specific board.
Others are to allow booting zImage.initrd as an ELF image.
Also I have added a "GO <address>" command to just jump to an address and
go.
Finally, I added an initial timeout to the serial input, so 8xxrom will run
a default command if left unattended.

Thanks for that.

I started with 8xxrom-0.3.0.  I heard about patches from Duncan, and I may
have added them, but I'm not sure.  Since the compressed tar is small, the
entire thing is attached.  I hope this is helpful for someone.

It is helpful to me. I will  try  to  merge  all  patches  that  I've
collected so far.

Is there somewhere else I should deliver this?  As far as I know, the
sourceforge home for 8xxrom hasn't really opened yet.

Yepp, Raphael has no time to care about this. I  met  him  yesterday,
and  we  agreed  to shift responsibilities. I received a message from
him today, that he assigned me and Magnus Damm (?) as  administrators
for the sourceforge tree.

That's correct, Raphael, isn't it?


I will try to coordinate changes a bit, and maybe start a re-write of
some parts of the code. I might have an engineer working on  this  by
mid-July to pick up what we have by then. My current intentions are:

* Make 8xxrom run on the TQM8xxL modules (99% of that are done)
* Add network boot using TFTP / BOOTP (Duncan Palmer is working on
  that, too)
* Add booting from PCMCIA / directly attached ATA disks (not working
  yet on the TQM8xxL)
* Add FLASH driver so that you can use the monitor to load an image
  over the network and write it to FLASH;
* Add some features needed for safe field upgradability (automatic
  selection between two or more boot images)

The list represents more or less the priorities as I see them at  the
moment.

Comments welcome, volunteers even more :-)

Wolfgang Denk

--
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-4596-87  Fax: (+49)-8142-4596-88  Email: wd@denx.de
Generally speaking, there are other ways to accomplish whatever it is
that you think you need ...                               - Doug Gwyn

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/