Re: problem on MPC8xx

Hi Jason:

I am sorry that another problem appeared.
After the /bin/sh ran, I can't see anything from console.
I open the compile switch "SERIAL_DEBUG_INTR" in uart.c,
then I can see the following message on console:

THRE...rs_interrupt_single(0, 2)...end.
THRE...rs_interrupt_single(0, 2)...end.
.
.
.

It means that the transmit interrupt is triggered, right?
But why I can't see anything?
And can you tell me that when shell outputs message to console,
which function it uses in uart.c? I think it should be
rs_8xx_write(), right? But I found that this function was not
called before interrupt happened.

Thanks!

LiuTao

I'm glad to hear you resolved your problem.  If I can lend you any other
assistance, let me know, I have gone all the way through porting the kernel
to a custom 860 board now and are familiar with solutions to some stumbling
blocks.

Jason

-----Original Message-----
From: LiuTao [mailto:tliu@ict.ac.cn]
Sent: Thursday, March 02, 2000 5:24 AM
To: Jason Wohlgemuth
Subject: Re: problem on MPC8xx

Hi Jason:

Thanks for your attention!
I found the problem in uart.c, the BRG is setup incorrectly.
I have resolved the problem.
Now, I can see message from console port.

Thanks.

LiuTao

** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/