ian geiser [off-list ref] wrote:

    I just installed a G3 upgrade card into my powercenter132
    It is a 400Mhz with 1Meg at 200Mhz....
    It registers under MacOS perfectly but i get the following under
    proc/cpuinfo:
    processor       : 0
    cpu             : 750
    temperature     : 0 C            <--Is this correct?!

Yeah, reading the temperature isn't actually implemented yet.

    clock           : 195MHz        <-- Is this correct?!

That is probably the value from Open Firmware.  I would guess that OF
on your motherboard doesn't know how to work out the clock frequency
correctly for the G3.  It doesn't matter, though.

Paul.

[[ This message was sent via the linuxppc-dev mailing list.  Replies are ]]
[[ not  forced  back  to the list, so be sure to Cc linuxppc-dev if your ]]
[[ reply is of general interest. Please check http://lists.linuxppc.org/ ]]
[[ and http://www.linuxppc.org/ for useful information before posting.   ]]