From: Baochen Qiang <redacted>

When doing "rmmod ath11k_pci", ath11k performs global SOC reset
and MHI reset, where 0 address access is captured by IOMMU. See
log below:

...
[  133.953860] ath11k_pci 0000:02:00.0: setting mhi state: DEINIT(1)
[  133.959714] ath11k_pci 0000:02:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x000a address=0x0 flags=0x0020]
[  133.973854] ath11k_pci 0000:02:00.0: MHISTATUS 0xff04
[  133.974095] ath11k_pci 0000:02:00.0: AMD-Vi: Event logged [IO_PAGE_FAULT domain=0x000a address=0x0 flags=0x0020]
...

This issue is also observed in SSR process, cause a similar
sequence as above is performed.

Such an invalid access occurs because, during rmmod or SSR, MSI
address is cleared but HW MSI functionality not disabled, thus HW
target is able to raise an MSI transaction with 0 as MSI address.

So it can be fixed by simply disabling MSI before reset. For SSR,
since MSI functionality is still needed after target is brought
back, we need to reenable it.

Also change naming of some interfaces related.

Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1

Signed-off-by: Baochen Qiang <redacted>
Signed-off-by: Jouni Malinen <redacted>
---
 drivers/net/wireless/ath/ath11k/pci.c | 27 ++++++++++++++++++++++-----
 1 file changed, 22 insertions(+), 5 deletions(-)

diff --git a/drivers/net/wireless/ath/ath11k/pci.c b/drivers/net/wireless/ath/ath11k/pci.c
index 7b3bce0ba76e..1094b53465bc 100644
--- a/drivers/net/wireless/ath/ath11k/pci.c
+++ b/drivers/net/wireless/ath/ath11k/pci.c

@@ -855,7 +855,18 @@ static void ath11k_pci_ce_irqs_enable(struct ath11k_base *ab)
 	}
 }
 
-static int ath11k_pci_enable_msi(struct ath11k_pci *ab_pci)
+static void ath11k_pci_enable_msi(struct pci_dev *dev, bool enable)
+{
+	u16 control;
+
+	pci_read_config_word(dev, dev->msi_cap + PCI_MSI_FLAGS, &control);
+	control &= ~PCI_MSI_FLAGS_ENABLE;
+	if (enable)
+		control |= PCI_MSI_FLAGS_ENABLE;
+	pci_write_config_word(dev, dev->msi_cap + PCI_MSI_FLAGS, control);
+}