Re: [PATCH] rtl8xxxu: disable interrupt_in transfer for 8188cu and 8192cu

On 01.07.21 18:33, chris.chiu@canonical.com wrote:

There will be crazy numbers of interrupts triggered by 8188cu and
8192cu module, around 8000~10000 interrupts per second, on the usb
host controller. Compare with the vendor driver source code, it's
mapping to the configuration CONFIG_USB_INTERRUPT_IN_PIPE and it is
disabled by default.

Since the interrupt transfer is neither used for TX/RX nor H2C
commands. Disable it to avoid the confusing interrupts for the
8188cu and 8192cu module which I only have for verification.

I tested the new code on the GARDENA smart gateway and it works as 
expected. Interrupts are greatly reduced while the same level of TX/RX 
performance could be measured as before the change: A (too) high 
percentage of retransmissions, but otherwise fine.

Tested-by: reto.schneider@husqvarnagroup.com

Kind regards,
Reto