On Monday, 22 February 2021 11:09:31 CET Maharaja Kennadyrajan wrote:

User can configure the beacon tx mode while bring-up the AP
or MESH. Hence, added the support in the nl80211/cfg80211
layer to honour the beacon tx mode configuration and pass
this value to the driver.

There is not a definition what this actually means. But I am guessing that you 
are mean the way the HW sends our the beacons for a multivif (beaconing) 
setup. And in this case, it is a per "phy" setting and not a per AP/meshpoint 
setting, right?

Kind regards,
	Sven