@@ -569,9 +569,12 @@
 						 (Rx beacon, probe rsp) */
 #define  RCR_ACCEPT_CRC32		BIT(8)  /* Accept CRC32 error packet */
 #define  RCR_ACCEPT_ICV			BIT(9)  /* Accept ICV error packet */
-#define  RCR_ACCEPT_DATA_FRAME		BIT(11)
-#define  RCR_ACCEPT_CTRL_FRAME		BIT(12)
-#define  RCR_ACCEPT_MGMT_FRAME		BIT(13)
+#define  RCR_ACCEPT_DATA_FRAME		BIT(11) /* Accept all data pkt or use
+						   REG_RXFLTMAP2 */
+#define  RCR_ACCEPT_CTRL_FRAME		BIT(12) /* Accept all control pkt or use
+						   REG_RXFLTMAP1 */
+#define  RCR_ACCEPT_MGMT_FRAME		BIT(13) /* Accept all mgmt pkt or use
+						   REG_RXFLTMAP0 */
 #define  RCR_HTC_LOC_CTRL		BIT(14) /* MFC<--HTC=1 MFC-->HTC=0 */
 #define  RCR_UC_DATA_PKT_INT_ENABLE	BIT(16) /* Enable unicast data packet
 						   interrupt */

@@ -651,9 +654,20 @@
 #define REG_LPNAV_CTRL			0x0694
 #define REG_WKFMCAM_CMD			0x0698
 #define REG_WKFMCAM_RWD			0x069c
-#define REG_RXFLTMAP0			0x06a0
-#define REG_RXFLTMAP1			0x06a2
-#define REG_RXFLTMAP2			0x06a4
+
+/*
+ * RX Filters: each bit corresponds to the numerical value of the subtype.
+ * If it is set the subtype frame type is passed. The filter is only used when
+ * the RCR_ACCEPT_DATA_FRAME, RCR_ACCEPT_CTRL_FRAME, RCR_ACCEPT_MGMT_FRAME bit
+ * in the RCR are low.
+ *
+ * Example: Beacon subtype is binary 1000 which is decimal 8 so we have to set
+ * bit 8 (0x100) in REG_RXFLTMAP0 to enable reception.
+ */
+#define REG_RXFLTMAP0			0x06a0	/* Management frames */
+#define REG_RXFLTMAP1			0x06a2	/* Control frames */
+#define REG_RXFLTMAP2			0x06a4	/* Data frames */
+
 #define REG_BCN_PSR_RPT			0x06a8
 #define REG_CALB32K_CTRL		0x06ac
 #define REG_PKT_MON_CTRL		0x06b4