On 2015-08-06 20:45, Peter Oh wrote:

On 08/06/2015 12:59 AM, Felix Fietkau wrote:

quoted

On 2015-08-06 09:43, Vasanthakumar Thiagarajan wrote:

quoted

On Wednesday 05 August 2015 05:51 PM, Felix Fietkau wrote:

quoted

On 2015-07-21 13:36, Vasanthakumar Thiagarajan wrote:

quoted

Add vendor/device id of QCA99X0 V2.0 to pci id table and
QCA99X0_HW_2_0_CHIP_ID_REV to ath10k_pci_supp_chips[] for
QCA99X0 to get detected by the driver.

Signed-off-by: Vasanthakumar Thiagarajan <redacted>

I just tested a 99X0 card, and I'm getting this:

[    8.742514] ath10k_pci 0000:01:00.0: enabling device (0140 -> 0142)
[    8.747173] ath10k_pci 0000:01:00.0: pci irq msi interrupts 1

irq_mode 0 reset_mode 0

quoted

quoted

[   11.793314] ath10k_pci 0000:01:00.0: failed to receive initialized

event from target: 00000000

quoted

quoted

[   11.793344] ath10k_pci 0000:01:00.0: failed to wait for target after

cold reset: -110

quoted

quoted

[   11.800814] ath10k_pci 0000:01:00.0: failed to reset chip: -110
[   11.809228] ath10k_pci: probe of 0000:01:00.0 failed with error -110

This is on an AP148 board with Linux 3.18, backports generated from
latest wireless-testing (2015-08-03) + all patches from kvalo's ath
tree.

Any idea about the version of AP148 that you are using?. By any chance

did

quoted

you check if QCA988X is working on the same board?.

No idea about the version, but QCA988X is working in the same slot.

QCA99X0 uses a different version of firmware from QCA988X.
Could you verify which firmware version or file name is using?

ath10k/QCA99X0/hw2.0/firmware-5.bin_10.4.1.00007-1 from git is
/lib/firmware/ath10k/QCA99X0/hw2.0/firmware-5.bin on the device.

However, this error shows up even before it gets to the point of loading
the firmware.

- Felix