Re: [PATCH V1] serial: imx: revert setup DCEDTE early and ensure DCD and RI irqs to be off

Hey Fabio,

On Wed, May 24, 2017 at 08:52:50AM -0300, Fabio Estevam wrote:

On Wed, May 24, 2017 at 7:32 AM, Steve Twiss
[off-list ref] wrote:

quoted

The USB to UART connection gets corrupted.
If this patch is applied to the kernel, the i.MX6 Q (quad), and only this board as far as
we know, starts to fail. This does *not* change the i.MX6DL and other sabre boards
have been tested on kernelci.org and do not see a problem.

An NXP/Freescale SABRESD i.MX6 Q board is requred.

My system for testing is to TFTP the Linux kernel over an ethernet connection. The
U-boot executes okay and the UART is working at that point. When the kernel loads
the console trace becomes garbled, in the sense that I get the some characters being
output to the console, in the style of the kernel starting up, but they are not correct.

I expect the kernel has started ok, but I am unable to read/write through the UART
console because of corruptions.

Console log with the output I am seeing with linux-next/v4.12-rc2

--- 8< ---

U-Boot 2009.08-00001-gf65536a (Jan 12 2015 - 15:47:19)

Thanks for your detailed explanation.

I also have a mx6q sabresd board here, but the error did not happen
when I use a recent U-Boot version.

I would like to use the same U-Boot version here as well to help
debugging this problem.

Could you please let me know which 2009.08 branch you used? Is it any
one from git.freescale.com
http://git.freescale.com/git/cgit.cgi/imx/uboot-imx.git/refs/heads ?

The problem is that RFDIV, RXTL and TXTL are overwritten in the UFCR
register.

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |