On Mon, Sep 12, 2016 at 05:22:58PM +0200, Nicolas Ferre wrote:

Le 12/09/2016 à 15:34, Richard Genoud a écrit :

quoted

Since commit 18dfef9c7f87 ("serial: atmel: convert to irq handling
provided mctrl-gpio"), interrupts from GPIOs are not disabled any more
when the serial port is closed, leading to an oops when the one of the
input pin is toggled (CTS/DSR/DCD/RNG).

This is only the case if those pins are used as GPIOs, i.e. declared
like that:
usart1: serial@f8020000 {
        /* CTS and DTS will be handled by GPIO */
        status = "okay";
        rts-gpios = <&pioB 17 GPIO_ACTIVE_LOW>;
        cts-gpios = <&pioB 16 GPIO_ACTIVE_LOW>;
        dtr-gpios = <&pioB 14 GPIO_ACTIVE_LOW>;
        dsr-gpios = <&pioC 31 GPIO_ACTIVE_LOW>;
        rng-gpios = <&pioB 12 GPIO_ACTIVE_LOW>;
        dcd-gpios = <&pioB 15 GPIO_ACTIVE_LOW>;
};

That's because modem interrupts used to be freed in atmel_shutdown().
After commit 18dfef9c7f87 ("serial: atmel: convert to irq handling
provided mctrl-gpio"), this code was just removed.
Calling atmel_disable_ms() disables the interrupts and everything works
fine again.

Tested on at91sam9g35-cm

(This patch doesn't apply on -stable kernels, fixes for 4.4 and 4.7 will
be sent after this one is applied.)

Signed-off-by: Richard Genoud <redacted>
Fixes: 18dfef9c7f87 ("serial: atmel: convert to irq handling provided mctrl-gpio")

I thinks it's a bit late for "4.8-fixes".

Greg, tell me if you want that I add the Cc: stable tag to this patch
(as advised by Uwe) and re-send?

I'll add it, no worries.

greg k-h