[PATCH -next 07/13] serial: 8250_early: Assume uart already initialized if no baud option
From: Peter Hurley <hidden>
Date: 2015-02-24 16:37:45
Also in:
lkml
Subsystem:
8250/16?50 (and clone uarts) serial driver, the rest, tty layer and serial drivers · Maintainers:
Greg Kroah-Hartman, Linus Torvalds, Jiri Slaby
The <baud><parity><bit> option string is not supplied if the earlycon is started via devicetree and OF_EARLYCON_DECLARE(). The option string is also not required if started via kernel command line parameters of the form: earlycon=uart,mmio,<addr> console=uart,mmio,<addr> If earlycon_device->baud is 0, then an option string was not supplied. In this case, assume the uart has already been initialized by the bootloader or firmware. Signed-off-by: Peter Hurley <redacted> --- drivers/tty/serial/8250/8250_early.c | 10 ++++++++-- 1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/tty/serial/8250/8250_early.c b/drivers/tty/serial/8250/8250_early.c
index d7b831b..1701d00 100644
--- a/drivers/tty/serial/8250/8250_early.c
+++ b/drivers/tty/serial/8250/8250_early.c@@ -149,12 +149,18 @@ static int __init early_serial8250_setup(struct earlycon_device *device, return 0; if (!device->baud) { + struct uart_port *port = &device->port; + unsigned int ier; + device->baud = probe_baud(&device->port); snprintf(device->options, sizeof(device->options), "%u", device->baud); - } - init_port(device); + /* assume the device was initialized, only mask interrupts */ + ier = serial8250_early_in(port, UART_IER); + serial8250_early_out(port, UART_IER, ier & UART_IER_UUE); + } else + init_port(device); device->con->write = early_serial8250_write; return 0;
--
2.3.0