On Mon, Jan 20, 2014 at 02:32:35PM +0530, Tushar Behera wrote:

uart_register_driver call binds the driver to a specific device
node through tty_register_driver call. This should typically happen
during device probe call.

In a multiplatform scenario, it is possible that multiple serial
drivers are part of the kernel. Currently the driver registration fails
if multiple serial drivers with same default major/minor numbers are
included in the kernel.

A typical case is observed with amba-pl011 and samsung-uart drivers.

NAK.  There should not be any other driver using amba-pl011's device numbers.

-- 
FTTC broadband for 0.8mile line: 5.8Mbps down 500kbps up.  Estimation
in database were 13.1 to 19Mbit for a good line, about 7.5+ for a bad.
Estimate before purchase was "up to 13.2Mbit".