On Fri, May 22, 2020 at 03:24:32PM -0700, Scott Branden wrote:

On 2020-05-18 5:37 a.m., Mimi Zohar wrote:

quoted

On Sun, 2020-05-17 at 23:22 -0700, Christoph Hellwig wrote:

quoted

On Fri, May 15, 2020 at 09:29:33PM +0000, Luis Chamberlain wrote:

quoted

On Wed, May 13, 2020 at 11:17:36AM -0700, Christoph Hellwig wrote:

quoted

Can you also move kernel_read_* out of fs.h?  That header gets pulled
in just about everywhere and doesn't really need function not related
to the general fs interface.

Sure, where should I dump these?

Maybe a new linux/kernel_read_file.h?  Bonus points for a small top
of the file comment explaining the point of the interface, which I
still don't get :)

Instead of rolling your own method of having the kernel read a file,
which requires call specific security hooks, this interface provides a
single generic set of pre and post security hooks.  The
kernel_read_file_id enumeration permits the security hook to
differentiate between callers.

To comply with secure and trusted boot concepts, a file cannot be
accessible to the caller until after it has been measured and/or the
integrity (hash/signature) appraised.

In some cases, the file was previously read twice, first to measure
and/or appraise the file and then read again into a buffer for
use.  This interface reads the file into a buffer once, calls the
generic post security hook, before providing the buffer to the caller.
  (Note using firmware pre-allocated memory might be an issue.)

Partial reading firmware will result in needing to pre-read the entire
file, most likely on the security pre hook.

The entire file may be very large and not fit into a buffer.
Hence one of the reasons for a partial read of the file.
For security purposes, you need to change your code to limit the amount
of data it reads into a buffer at one time to not consume or run out of much
memory.

Hm? That's not how whole-file hashing works. :)

These hooks need to finish their hashing and policy checking before they
can allow the rest of the code to move forward. (That's why it's a
security hook.) If kernel memory utilization is the primary concern,
then sure, things could be rearranged to do partial read and update the
hash incrementally, but the entire file still needs to be locked,
entirely hashed by hook, then read by the caller, then unlocked and
released.

So, if you want to have partial file reads work, you'll need to
rearchitect the way this works to avoid regressing the security coverage
of these operations.

So, probably, the code will look something like:


file = kernel_open_file_for_reading(...)
	file = open...
	disallow_writes(file);
	while (processed < size-of-file) {
		buf = read(file, size...)
		security_file_read_partial(buf)
	}
	ret = security_file_read_finished(file);
	if (ret < 0) {
		allow_writes(file);
		return PTR_ERR(ret);
	}
	return file;

while (processed < size-of-file) {
	buf = read(file, size...)
	firmware_send_partial(buf);
}

kernel_close_file_for_reading(file)
	allow_writes(file);


-- 
Kees Cook