Hi Alexandre,

On Fri, Dec 7, 2018 at 10:34 AM Alexandre Belloni
[off-list ref] wrote:

On 06/12/2018 11:36:59+0100, Geert Uytterhoeven wrote:

quoted

quoted

+The following properties may not be supported by all drivers. However, if a
+driver wants to support one of the below features, it should adapt the bindings
+below.
+- trickle-resistor-ohms : Selected resistor for trickle charger. Should be given

Can this resistor be less than 1 ohm?
trickle-resistor-milli-ohms?

Well, this is what current drivers already use so we are stuck with that
for now.

The value should be a few kOhm anyway. I think the lowest I know about
is 250 Ohm.

OK, good to know. Thanks!

Gr{oetje,eeting}s,

                        Geert

-- 
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds