On Sun, Feb 20, 2011 at 02:33:01PM +0100, Bart Van Assche wrote:

Hello,

A convenient way to provide high availability when using fail-over
between two IPv4 iSCSI servers is to configure the HA software such
that a secondary IPv4 address is only assigned to the active server.
I'd like to build a HA SRP setup using a similar approach. This leads
me to the following question: does there exist an equivalent of
virtual IP addresses for IB ? As far as I can see in the IBTA specs a
subnet manager can assign a secondary GID to an IB HCA port
dynamically.

Does any of the existing IB switches support this ? If so, how does
communication between HA software and IB switch happen ?

Does OpenSM support assigning secondary GIDs to a HCA port ?

Unfortunately this is an area where the IB spec has quite a lot of
richness but AFAIK it doesn't get used too much..

I don't think IP like GID migration is appropriate for IB, GUIDs
should be fabric unique. I'd suggest you should look at supporting
multiple GIDs registered for a single service ID and use those GIDs as
the set of fail over end ports. Supporting setting up APM as well
would be great. ;)

In IB if a port falls off the subnet the SM will not return paths for
it, so you can tell quickly that a service record is dead without
incuring a timeout. Essentially the SM takes the roll of the HA
software you see in IP land.

Jason
--
To unsubscribe from this list: send the line "unsubscribe linux-rdma" in
the body of a message to majordomo-u79uwXL29TY76Z2rM5mHXA@public.gmane.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html