Thread (66 messages) 66 messages, 5 authors, 2024-02-29

Re: [PATCH v5 00/14] dm-raid/md/raid: fix v6.7 regressions

From: Benjamin Marzinski <bmarzins@redhat.com>
Date: 2024-02-19 16:05:44
Also in: dm-devel, lkml

On Sun, Feb 18, 2024 at 09:24:31AM +0800, Yu Kuai wrote:
Hi,

在 2024/02/16 13:46, Benjamin Marzinski 写道:
quoted
On Thu, Feb 15, 2024 at 02:24:34PM -0800, Song Liu wrote:
quoted
On Thu, Feb 1, 2024 at 1:30 AM Yu Kuai [off-list ref] wrote:
quoted
[...]
quoted
[1] https://lore.kernel.org/all/CALTww29QO5kzmN6Vd+jT=-8W5F52tJjHKSgrfUc1Z1ZAeRKHHA@mail.gmail.com/ (local)

Yu Kuai (14):
   md: don't ignore suspended array in md_check_recovery()
   md: don't ignore read-only array in md_check_recovery()
   md: make sure md_do_sync() will set MD_RECOVERY_DONE
   md: don't register sync_thread for reshape directly
   md: don't suspend the array for interrupted reshape
   md: fix missing release of 'active_io' for flush
Applied 1/14-5/14 to md-6.8 branch (6/14 was applied earlier).

Thanks,
Song
I'm still seeing new failures that I can't reproduce in the 6.6 kernel,
specifically:

lvconvert-raid-reshape-stripes-load-reload.sh
lvconvert-repair-raid.sh

with lvconvert-raid-reshape-stripes-load-reload.sh Patch 12/14
("md/raid456: fix a deadlock for dm-raid456 while io concurrent with
reshape") is changing a hang to a corruption. The issues is that we
can't simply fail IO that crosses the reshape position. I assume that
the correct thing to do is have dm-raid reissue it after the suspend,
when the reshape can make progress again. Perhaps something like this,
only less naive (although this patch does make the test pass for me).
Heinz, any thoughts on this? Otherwise, I'll look into this a little
more and post a RFC patch.
Does the corruption looks like below?
There isn't a kernel stack trace.  The test
lvconvert-raid-reshape-stripes-load-reload.sh does some IO to a
filesytem on top of a raid device, and then starts a reshape, and
repeatedly suspends the device. After all that, it runs fsck to see if
the filesystem is clean, and on runs where I see "dm-raid456: io failed
across reshape position while reshape can't make progress" I see
filesystem errors:

------------------------------------------------------------------
[ 0:25.219] fsck from util-linux 2.39.2
[ 0:25.224] e2fsck 1.47.0 (5-Feb-2023)
[ 0:25.232] Warning: skipping journal recovery because doing a read-only
filesystem check.
[ 0:25.233] Pass 1: Checking inodes, blocks, and sizes
[ 0:25.233] Pass 2: Checking directory structure
[ 0:25.234] Pass 3: Checking directory connectivity
[ 0:25.234] Pass 4: Checking reference counts
[ 0:25.234] Pass 5: Checking group summary information
[ 0:25.234] Feature orphan_present is set but orphan file is clean.
[ 0:25.235] Clear? no
[ 0:25.235] 
[ 0:25.235] 
[ 0:25.235] /tmp/LVMTEST35943.Iuo9Ro5tCY/dev/mapper/LVMTEST35943vg-LV1:
********** WARNING: Filesystem still has errors **********
[ 0:25.235] 
[ 0:25.235] /tmp/LVMTEST35943.Iuo9Ro5tCY/dev/mapper/LVMTEST35943vg-LV1:
13/2560 files (0.0% non-contiguous), 5973/10240 blocks
------------------------------------------------------------------

O.k. corruption is too strong a word. Lets just call it a filesystem
that got a write error, and now is in an unclean state according to
fsck. I'm pretty sure that this is recoverable.
[12504.959682] BUG bio-296 (Not tainted): Object already free
[12504.960239]
-----------------------------------------------------------------------------
[12504.960239]
[12504.961209] Allocated in mempool_alloc+0xe8/0x270 age=30 cpu=1 pid=203288
[12504.961905]  kmem_cache_alloc+0x36a/0x3b0
[12504.962324]  mempool_alloc+0xe8/0x270
[12504.962712]  bio_alloc_bioset+0x3b5/0x920
[12504.963129]  bio_alloc_clone+0x3e/0x160
[12504.963533]  alloc_io+0x3d/0x1f0
[12504.963876]  dm_submit_bio+0x12f/0xa30
[12504.964267]  __submit_bio+0x9c/0xe0
[12504.964639]  submit_bio_noacct_nocheck+0x25a/0x570
[12504.965136]  submit_bio_wait+0xc2/0x160
[12504.965535]  blkdev_issue_zeroout+0x19b/0x2e0
[12504.965991]  ext4_init_inode_table+0x246/0x560
[12504.966462]  ext4_lazyinit_thread+0x750/0xbe0
[12504.966922]  kthread+0x1b4/0x1f0

I assum that this is a dm problem and I'm still trying to debug it.
Can you explain more why IO that crosses the reshape position can't
fail directly?
Maybe I'm missing something here, but if the filesystem is trying to
write out data to the device, and we fail that IO, why would that not
cause problems, whatever we call it? 

[ 0:18.792] 3,6342,47220996156,-;dm-raid456: io failed across reshape
position while reshape can't make progress
[ 0:18.792] 3,6343,47220996182,-;Aborting journal on device dm-39-8.
[ 0:18.792] 3,6344,47221411730,-;dm-raid456: io failed across reshape
position while reshape can't make progress
[ 0:18.792] 3,6345,47221411746,-;Buffer I/O error on dev dm-39, logical
block 740, lost sync page write
[ 0:18.792] 3,6346,47221416194,-;JBD2: I/O error when updating journal
superblock for dm-39-8.

Does this test not fail for you? Or does it simply also fail in the 6.6
kernel.

-Ben
 
Thanks,
Kuai
quoted
=========================================================
diff --git a/drivers/md/dm-raid.c b/drivers/md/dm-raid.c
index ed8c28952b14..ff481d494b04 100644
--- a/drivers/md/dm-raid.c
+++ b/drivers/md/dm-raid.c
@@ -3345,6 +3345,14 @@ static int raid_map(struct dm_target *ti, struct bio *bio)
  	return DM_MAPIO_SUBMITTED;
  }
+static int raid_end_io(struct dm_target *ti, struct bio *bio,
+		       blk_status_t *error)
+{
+	if (*error != BLK_STS_IOERR || !dm_noflush_suspending(ti))
+		return DM_ENDIO_DONE;
+	return DM_ENDIO_REQUEUE;
+}
quoted
+
  /* Return sync state string for @state */
  enum sync_state { st_frozen, st_reshape, st_resync, st_check, st_repair, st_recover, st_idle };
  static const char *sync_str(enum sync_state state)
@@ -4100,6 +4108,7 @@ static struct target_type raid_target = {
  	.ctr = raid_ctr,
  	.dtr = raid_dtr,
  	.map = raid_map,
+	.end_io = raid_end_io,
  	.status = raid_status,
  	.message = raid_message,
  	.iterate_devices = raid_iterate_devices,
=========================================================
quoted
quoted
   md: export helpers to stop sync_thread
   md: export helper md_is_rdwr()
   dm-raid: really frozen sync_thread during suspend
   md/dm-raid: don't call md_reap_sync_thread() directly
   dm-raid: add a new helper prepare_suspend() in md_personality
   md/raid456: fix a deadlock for dm-raid456 while io concurrent with
     reshape
   dm-raid: fix lockdep waring in "pers->hot_add_disk"
   dm-raid: remove mddev_suspend/resume()

  drivers/md/dm-raid.c |  78 +++++++++++++++++++--------
  drivers/md/md.c      | 126 +++++++++++++++++++++++++++++--------------
  drivers/md/md.h      |  16 ++++++
  drivers/md/raid10.c  |  16 +-----
  drivers/md/raid5.c   |  61 +++++++++++----------
  5 files changed, 192 insertions(+), 105 deletions(-)

--
2.39.2
.
  
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help