Re: [PATCH 0/2] Check node nums for cluster raid

Hi Jes,

On 05/04/2016 11:12 AM, Jes Sorensen wrote:

Guoqing Jiang [off-list ref] writes:

quoted

For cluster raid, we do need at least two nodes for it,
the two patches add the checks before create and change
bitmap.

Thanks,
Guoqing

Guoqing Jiang (2):
   Create: check the node nums when create clustered raid
   super1: don't update node nums if it is not more than 1

  Create.c | 7 ++++++-
  super1.c | 5 +++++
  2 files changed, 11 insertions(+), 1 deletion(-)

Hi Guoqing,

I am a little confused on this one - albeit I haven't looked at it in
detail. Why should it not be possible to start a cluster with one node?
In theory you should be able to do that, and then add nodes later?

The "nodes" means how many nodes could run with the clustered raid.
IOW, if nodes is set to 1, then we can't assemble the clustered raid in
node B after clustered raid is created in node A.

And we had provided below protection in md-cluster.c, so it doesn't make
sense to create clustered raid with "nodes = 1" since we can't use this raid
across cluster.

f (nodes < cinfo->slot_number) {
                pr_err("md-cluster: Slot allotted(%d) is greater than available slots(%d).",
                        cinfo->slot_number, nodes);
                ret = -ERANGE;
                goto err;
}

Regards,
Guoqing