NeilBrown wrote:

On Mon, 26 May 2014 20:07:11 +0200 Sebastian Herbszt [off-list ref] wrote:

[snip]

quoted

How can I identify a failed array?
array_state reports "clean", the last raid member stays "in_sync" and
the value in degraded doesn't equal raid_disks.

You know the array is "failed" when you get an IO error.

When a RAID1 array gets down to just one drive remaining, it starts acting
like it is just one drive.
How do you tell if is single plain ordinary drive is failed?  You get an IO
error.  ditto with RAID1.

NeilBrown

Since md knows the current state I hoped it would provide the required
information for an application to distinguish between degraded and failed
arrays. Any reason this is not the case?
This would allow mdadm to not only report "DegradedArray" but also
"FailedArray". Currently it does not generate any event when the last drive
fails.

Sebastian