On Wed, 13 Feb 2013, Sebastian Riemer wrote:

On 13.02.2013 03:38, NeilBrown wrote:

quoted

diff --git a/drivers/md/md.c b/drivers/md/md.c
index 8b557d2..292cc2f 100644
--- a/drivers/md/md.c
+++ b/drivers/md/md.c

@@ -6529,7 +6529,17 @@ static int md_ioctl(struct block_device *bdev, fmode_t mode,
 			mddev->ro = 0;
 			sysfs_notify_dirent_safe(mddev->sysfs_state);
 			set_bit(MD_RECOVERY_NEEDED, &mddev->recovery);
-			md_wakeup_thread(mddev->thread);
+			/* mddev_unlock will wake thread */
+			/* If a device failed while we were read-only, we
+			 * need to make sure the metadata is updated now.
+			 */
+			if (test_bit(MD_CHANGE_DEVS, &mddev->flags)) {
+				mddev_unlock(mddev);
+				wait_event(mddev->sb_wait,
+					   !test_bit(MD_CHANGE_DEVS, &mddev->flags) &&
+					   !test_bit(MD_CHANGE_PENDING, &mddev->flags));
+				mddev_lock(mddev);
+			}
 		} else {
 			err = -EROFS;
 			goto abort_unlock;

Thanks, Neil!

I can confirm the issue on 3.4.y and that your patch fixes it reliably.

Acked-by: Sebastian Riemer <redacted>

Running with this patch against 3.8.0rc7 with the following results:

  auto-read-only
  * mdadm --fail   - success
  * mdadm --remove - success

  read-only
  * mdadm --fail   - success
  * mdadm --remove - EROFS

Quick question for Neil -- should the sysfs MD component device state 
file interface perform the same transition from auto-read-only to 
read-write, or is that route intended for more granular changes?

Thanks,

-- Joe