On Wed, 5 Sep 2012 09:32:16 -0500 Brassow Jonathan [off-list ref]
wrote:
On Sep 4, 2012, at 8:44 PM, NeilBrown wrote:
quoted
On Thu, 23 Aug 2012 10:31:54 -0500 Jonathan Brassow [off-list ref]
wrote:
quoted
Neil,
There are two ways I see to fix the problem of the "sync" table argument
not causing the array to re-sync. We could set mddev->events to
UINT_MAX and force an mddev/bitmap event mismatch - causing the bitmap
code to set BITMAP_STALE itself. Otherwise, we can do as I have below
and set BITMAP_STALE ourselves. The real difference is whether this is
done before or after md_run(). The first solution can be done before
md_run(); the second cannot because the bitmap is allocated during
md_run(). Either solution works and correctly sets the bitmap to stale
before bitmap_load() is called. So, rather than having to think about
issues that come with setting events to UINT_MAX, I chose to set the
bitmap stale after md_run().
I'm not at all sure this is the right way to look at the issue.
The only reason that we have 'sync' and 'nosync' table args is because
originally we weren't storing any metadata on disk. The 'in-sync?' state of
the array is important metadata, so it needed to be given to md via a table
option.
If you have a bitmap, then you are storing this information in metadata, so
including it as a table option is redundant and - as you noticed - ignored.
If you want to assert that the data in the bitmap is incorrect, then I think
the best approach is to change it so that it is correct.
i.e. if you want to assert that an array is not in-sync and should be fully
'synced', then the right thing to do is to write lots of '1's to the bitmap
before trying to assemble the array.
However I'm not violently against the patch - though I would be against
fiddling with event_count. It does seem unpleasantly asymmetric though.
The 'sync' option says 'assume all bits in the bitmap are set', but the
'nosync' option doesn't say 'assume all bits in the bitmap are clear'.
Is simply writing to the bitmap when you want to force some behaviour an
option, or do you really really want "sync" to mean "please ignore the
bitmap"? (or maybe an "ignorebitmap" option is what we want??).
For me, the 'sync' and 'nosync' args are not just a vestige of when we didn't have metadata; but also a form of continuity with dm-raid1. The 'sync' option has - for device-mapper - always been a way to reset the bitmap and force a resync.
With dm-raid1, it is dm-log.c which interprets the 'sync' and 'nosync' flags.
The meaning seems to be:
- 'sync' - ignore the log, force the array to be synced (i.e. set all
regions to 'dirty')
- 'nosync' - ignore the log, don't sync the array (i.e. set all regions
to 'clean')
- neither of those - use the log to determine whether to sync or not.
If you want to make the flags to dm-raid mean exactly the same as that (i.e.
if either sync or nosync is present, we ignore the metadata) then I would be
happy with that. I don't think that is quite what your patch does though -
it only does half of it.
NeilBrown