Re: [patch 0/4 v2] optimize raid1 read balance for SSD

From
David Brown <hidden>
Date
2012-06-28 06:31:31
Reply to
NeilBrown, 2012-06-28
On 28/06/12 05:40, NeilBrown wrote:
On Thu, 28 Jun 2012 11:29:01 +0800 Shaohua Li[off-list ref]  wrote:
quoted
On Thu, Jun 28, 2012 at 11:06:16AM +1000, NeilBrown wrote:
quoted
On Wed, 13 Jun 2012 17:09:22 +0800 Shaohua Li[off-list ref]  wrote:
<snip>
quoted
quoted
General balancing is a little harder as the decision is made in the context
of all active devices.  In particular we need to know how to choose between a
seek-penalty device and a no-seek-penalty device, if they both have requests
queued to them and the seek-penalty device is a long way from the target.

Maybe:
  - if the last request to some device is within optimal-io-size of this
    requests, then send this request to that device.
  - if either of two possible devices has no seek penalty, choose the one with
    the fewest outstanding requests.
  - if both of two possible devices have a seek-penalty, then choose the
    closest

I think this will do the same as the current code for 'rotational' devices,
and will be close to what your code does for 'non-rotational' devices.
This is close to what I did except for the case of one hard disk and one SSD.
Talking about heterogeneous arrary, I assume people only do it with two
different hard disks or two different ssd. Will people really mix hard disk and
SSD? A hard disk can only drive 600 IOPS while a lowend SATA SSD can drive 20k
~ 40k IOPS. Plusing 600 to 20k doesn't significantly change IOPS.
I'm fairly sure people will try it, even if it doesn't make sense. :-)

It possibly would make sense if the slower device was marked "write-mostly",
but that disables read-balance, so what we do with read balance might be
irrelevant.
I would imagine that an SSD paired with an HD (or a partition on an HD) in RAID1 would be very common for small setups - at least until the current experimental flash cache systems solidify and mature.  You get the speed of the SSD, and the safety of RAID1 without the cost of two SSDs.  It is normal today to use write-mostly on the HD - but I'd guess a fair number of users don't think to do that.  And with good balancing from these patches, there is no need - and you can get the best from both devices.  SSD's are much faster than HD's when there is seeking involved - but for streamed accesses the difference is smaller, and it's good to have both devices available for reads.
I don't want to assume devices have different speeds unless explicitly told
so, and the "rotational" flag doesn't clearly imply anything about the speed
of the device, only about seek latency.  So e.g. I wouldn't want to always
assume that a non-rotational device were faster than a rotational device,
even though that may be the case in lots of situations.

I'd be less concerned about heterogeneous arrays with RAID10 as it makes less
sense there.  But I certainly want to at least acknowledge the possibility
for RAID1.

thanks,
NeilBrown
  
Thread (10 messages) 10 messages, 4 authors, last reply 2012-06-28
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help