Thread (4 messages) 4 messages, 3 authors, 2010-01-18

Re: non-fresh data unavailable bug

From: Brett Russ <hidden>
Date: 2010-01-15 15:36:39

On 01/14/2010 02:24 PM, Michael Evans wrote:
On Thu, Jan 14, 2010 at 7:10 AM, Brett Russ[off-list ref]  wrote:
quoted
Slightly related to my last message here Re:non-fresh behavior, we have seen
cases where the following happens:
* healthy 2 disk raid1 (disks A&  B) incurs a problem with disk B
* disk B is removed, unit is now degraded
* replacement disk C is added; recovery from A to C begins
* during recovery, disk A incurs a brief lapse in connectivity.  At this
point C is still up yet only has a partial copy of the data.
* a subsequent assemble operation on the raid1 results in disk A being
kicked out as non-fresh, yet C is allowed in.
I believe the desired and logical behavior here is to refuse running
an incomplete array unless explicitly forced to do so.  Incremental
assembly might be what you're seeing.
This brings up a good point.  I didn't mention that the assemble in the 
last step above was forced.  Thus, the "bug" I'm reporting is that under 
duress, mdadm/md chose to assemble the array with a partially recovered 
(but "newer") member instead of the older member which was the recovery 
*source* for the newer member.

What I think should happen is members that are *destinations* for 
recovery should *never* receive a higher event count, timestamp, or any 
other marking than the recovery sources.  By definition they are 
incomplete and can't be trusted, thus they should never trump a complete 
member during assemble.  I would assume the code already does this but 
perhaps there is a hole.

One other piece of information that may be relevant--we're using 2 
member RAID1 units with one member marked write-mostly.  At this time, I 
don't have the specifics for which member (A or B) was the write-mostly 
member in the example above, but I can find that out.
I very much recommend running it read-only until you can determine which
assembly pattern produces the most viable results.
Good tip.  We were able to manually recover the array in the case 
outlined above, now we're looking back to fixing the kernel to prevent 
it happening again.

Thanks,
Brett
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help