Michael Evans [off-list ref] writes:
Advice point 2; which my howto should mention: For boot devices you'll
probably want to use the 1.0 mdadm label format (not 1.1 or 1.2, which
are the same but change where the label is stored) for just the boot
raid 1.0 only. It will also mention some things you should be extra
careful about...
Like mounting the bare devices in that raid set by mistake.
Oh, and you'll also very likely want grub to read the /boot
filesystem, which is why it must be on a partition followed by the
raid header, instead of a partition containing a raid header and raid
protected partition. That use is OK since grub operates read-only.
How far is the support for all superblock formats in grub2?
MfG
Goswin