Re: raid10 layout for 2xSSDs

From
Goswin von Brederlow <hidden>
Date
2009-11-17 04:46:25
Christopher Chen [off-list ref] writes:
On Mon, Nov 16, 2009 at 6:29 AM, Kasper Sandberg [off-list ref] wrote:
quoted
Hello.

I've been wanting to create a raid10 array of two SSDs, and I am
currently considering the layout.

As i understand it, near layout is similar to raid1, and will only
provide a speedup if theres 2 reads at the same time, not a single
sequential read.

so the choice is really between far and offset. As i see it, the
difference is, that offset tries to reduce the seeking for writing
compared to far, but that if you dont consider the seeking penalty,
average sequential write speed across the entire array should be roughly
the same with offset and far, with offset perhaps being a tad more
"stable", is this a correct assumption? if it is, that would mean offset
provides a higher "garantueed" speed than far, but with a lower maximum
speed.
Do you plan to have more than two devices in the array? Raid 10 isn't
magic. If you don't have more than do devices, I suppose your seek
time might be half for reads (and higher for writes), but you won't be
able to do any striping.

I'm a bit confused as to the number of people popping in recently
wanting to run raid 10 on two disk "arrays".

cc
I think you are missing the fact that linux has a special raid10
module. This is not just a raid0 over raid1 (or raid1 over raid0).
The raid10 module is much more flexible and allows to have X copies of
the data on Y disks (for any X <= Y) in different layouts.

The layouts are like this (for 2 copies on 2 disks):

near (same as raid1):

Disk A: 0 1 2 3 4 5 6 7 8 9
Disk B: 0 1 2 3 4 5 6 7 8 9 

offset:

Disk A: 0 1 2 3 4 5 6 7 8 9
Disk B: 1 0 3 2 5 4 7 6 9 8

far:

Disk A: 0 2 4 6 8 1 3 5 7 9
Disk B: 1 3 5 7 9 0 2 4 6 8

In the case of offset and far copies you can see that the data is
striped like in raid0 and the raid10 module will read data from
multiple drives in parallel even with a single stream.

In raid10 far mode the read will also (afaik, not 100% sure) always
come from the first half of the disk. With rotational disks that is
usualy the faster part. So you not only get double the read speed from
striping but also more speed from the disks itself. For example my
disk does 80MB/s at the start, 60MB/s in the middle and 40MB/s at the
end. Reads will only use the 80-60MB/s range now. Jupey.

MfG
        Goswin
Thread (1 message) 1 message, 1 author, last reply 2009-11-17
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help