Re: Requesting replace mode for changing a disk

"Leslie Rhorer" [off-list ref] writes:

quoted

This is one of many things proposed occasionally here, no real
objection, sometimes loud support, but no one actually *does* the code.

	At the risk of being a metoo, I would really love this feature.

quoted

You have described the problem exactly, and the solution is still to do
it manually. But you don't need to fail the drive long term, if you can
stop the array for a few moments. You stop the array, remove the suspect
drive,

Um, how, exactly?  That is to say, after stopping the array, how does one
remove the drive?  From the next step in your suggestion, it doesn't seem
tome you are talking about physically removing the drive, so how does one
remove a drive from a stopped array for this purpose?  I didn't think that
either

	mdadm -r <drive> <array>
or

	mdadm -f <drive> <array>

could be used on a stopped array.  Am I mistaken?

quoted

create a raid1 of the suspect drive marked write-mostly and the
new spare,

But doesn't creating the array with the drive wipe the contents?  If so, it
doesn't seem to me this provides much redundancy.

quoted

then add the raid1 in place of the suspect drive.

Before starting the array?  If so, how?  Or should one do an assemble
including the newly minted RAID1?  I thought mdadm would take the newly
added drive to be blank, even if it isn't.

quoted

For any
chunks present on the new drive the reads will go there, reducing

Huh?  Are you saying any read which finds one chunk missing will
automatically write back the missing data (doing a spot rebuild), or
something else?

quoted

access, while data is copied from the old to the new in resync, and

See my query above.  It seems to me you are saying the RAID1 can be created
without wiping the drive.

quoted

writes still go to the old suspect drive so if the new drive fails you
are no worse off.

I think I would expect the old drive to be more likely to fail than the new.

quoted

When the raid1 is clean you stop the main array and
back the suspect drive out.

OK, basically the same question.  How does one disassemble the RAID1 array
without wiping the data on the new drive?

I think he ment this:

mdadm --stop /dev/md0
mdadm --build /dev/md9 --chunk=64k --level=1 --raid-devices=2 /dev/suspect /dev/new
mdadm --assemble /dev/md0 /dev/md9 /dev/other ...

MfG
        Goswin