On Sunday January 27, keld@dkuug.dk wrote:
On Mon, Jan 28, 2008 at 07:13:30AM +1100, Neil Brown wrote:
quoted
On Sunday January 27, keld@dkuug.dk wrote:
quoted
Hi
I have tried to make a striping raid out of my new 4 x 1 TB
SATA-2 disks. I tried raid10,f2 in several ways:
1: md0 = raid10,f2 of sda1+sdb1, md1= raid10,f2 of sdc1+sdd1, md2 = raid0
of md0+md1
2: md0 = raid0 of sda1+sdb1, md1= raid0 of sdc1+sdd1, md2 = raid01,f2
of md0+md1
3: md0 = raid10,f2 of sda1+sdb1, md1= raid10,f2 of sdc1+sdd1, chunksize of
md0 =md1 =128 KB, md2 = raid0 of md0+md1 chunksize = 256 KB
4: md0 = raid0 of sda1+sdb1, md1= raid0 of sdc1+sdd1, chunksize
of md0 = md1 = 128 KB, md2 = raid01,f2 of md0+md1 chunksize = 256 KB
5: md0= raid10,f4 of sda1+sdb1+sdc1+sdd1
Try
6: md0 = raid10,f2 of sda1+sdb1+sdc1+sdd1
That I already tried, (and I wrongly stated that I used f4 in stead of
f2). I had two times a thruput of about 300 MB/s but since then I could
not reproduce the behaviour. Are there errors on this that has been
corrected in newer kernels?
No, I don't think any performance related changes have been made to
raid10 lately.
You could try increasing the read-ahead size. For a 4-drive raid10 it
defaults to 4 times the read-ahead setting of a single drive, but
increasing substantially (e.g. 64 times) seem to increase the speed of
"dd" reading a gigabyte.
Whether that will actually affect your target workload is a different question.
quoted
Also try raid10,o2 with a largeish chunksize (256KB is probably big
enough).
I tried that too, but my mdadm did not allow me to use the o flag.
My kernel is 2.6.12 and mdadm is v1.12.0 - 14 June 2005.
can I upgrade the mdadm alone to a newer version, and then which is
recommendable?
You would need a newer kernel and a newer mdadm to get raid10 - offset
mode.
NeilBrown