Re: Offtopic: hardware advice for SAS RAID6

From
Sven Rudolph <hidden>
Date
2007-11-23 11:22:57
Richard Michael [off-list ref] writes:
I'm considering my first SAS purchase.  I'm planning to build a software
RAID6 array using a SAS JBOD attached to a linux box.  I haven't decided
on any of the hardware specifics.

I'm leaning toward this PCI express LSI 3801e controller:
http://www.lsi.com/storage_home/products_home/host_bus_adapters/sas_hbas/lsisas3801e/index.html
I use a very similiar controllers, the LSI 3442X-R and 3442E-R. They
have only one external connector, and this is a different connector
type. It looks a bit more stable (mechanically), but this might be a
matter of taste and I have never used the other connector type.  (I
had to update the controllers using the latest firmware available on
the LSI web site.)
The JBOD would ideally be 1U or 2U holding 8 or 10 disks.  If I
understand SAS correctly, I'd probably have a unit with 2 SFF-8088
miniSAS connectors (although, I believe these connectors only support 4
devices, so if the JBOD is >8 disks, I don't know what would happen).
The JBODs that I am aware of use internal SAS port expanders (see
<http://en.wikipedia.org/wiki/Serial_Attached_SCSI#SAS_Expanders>). The
connection to the host has four SAS lanes (the concept is similiar to
the up to 16 lanes on a PCI-Express card). Each disk is connected via
one SAS lane, and all these lanes are switched by the port
expander. So you do not need 8 lanes on the host computer in order to
connect 8 disks. 

I use DELLs MD1000 JBOD (some with SATA, some with SAS), and it works
fine. I have up to three JBODs connected to one SAS host port.
I'd appreciate feedback and suggestions on the hardware above, or a
discussion of the performance.  (E.g. a discussion of SAS
ports/bandwith, PCI express lanes/bandwidth, disks and network to
determine the through put of this setup.)
Currently I don't see limits that must be considered. Simple math with
bandwidths. Nowadays I prefer PCI-Express over PCI-X. AFAIR the LSI
cards have 8 PCI-Express lanes, so you need a matching port on the
mainboard.

	Sven
Thread (1 message) 1 message, 1 author, last reply 2007-11-23
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help