Re: strange performance of raid0

Keld Jørn Simonsen wrote:

Hi

I have some strange performance results on a raid0
I have 4 IDE disks on two controllers, the one on the motherboard of the duron 1 GHz mackine, the other a promise TX2 plus SATA + PATA controller. I run kernel 2.4.22

The disks and hdparm -t on each of them

/dev/hdc1 seagate 80 GB                   16 MB/s
/dev/sda1 maxtor sata 200 GB              50 MB/s
/dev/sdb7 maxtor 160 GB                   54 MB/s

Well, if you're lucky, these might be useful as comparative numbers between the different drives on the same system.  Just as likely not, though, hdparm rather sucks as a benchmark.

The partitions are al about 5 GB each.

If I make a raid0 device of all of them I get a thruput of 45 MB/s
IIf I exclude the hdc1 partition, I get around 75 MB/s.
The system is a little loaded - but that would be normal operating
conditions. CPU is 90 % idle. I have about 100 MB free RAM.

Let's assume that the above numbers have a basis in reality.  :)  If you've got disks with widely varying speeds, then the best performance can often be hand from setting up a linear RAID volume, rather than a RAID0.  RAID 0 is really designed to have matching disks, as it distributes data evenly across them.  With Linear, and ext2 (erm, I'm assuming 3 as well, I haven't heard anything different), you can sometimes get better performance with smaller writes, because ext2 "scatters" data around the filesystem, in order to avoid fragmentation.  HTH,
	Greg
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html