md0: resyncing spare disk sdb1 to replace failed disk
RAID1 conf printout:
 --- wd:1 rd:2 nd:2
 disk 0, s:0, o:1, n:0 rd:0 us:1 dev:sda1 
 disk 1, s:0, o:0, n:1 rd:1 us:0 dev:[dev 00:00]
 disk 2, s:1, o:0, n:2 rd:2 us:1 dev:sdb1 
 disk 3, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
 disk 4, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
 disk 5, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
 disk 6, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
...
 disk 26, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
RAID1 conf printout:
 --- wd:1 rd:2 nd:2
 disk 0, s:0, o:1, n:0 rd:0 us:1 dev:sda1 
 disk 1, s:0, o:0, n:1 rd:1 us:0 dev:[dev 00:00]
 disk 2, s:1, o:1, n:2 rd:2 us:1 dev:sdb1 
 disk 3, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
 disk 4, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
 disk 5, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
 disk 6, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
...
 disk 26, s:0, o:0, n:0 rd:0 us:0 dev:[dev 00:00]
md: syncing RAID array md0
md: minimum _guaranteed_ reconstruction speed: 100 KB/sec/disc.
md: using maximum available idle IO bandwith (but not more than 100000 
KB/sec) for reconstruction.
md: using 124k window, over a total of 128384 blocks.
md: trying to hot-add sdb3 to md2 ...
...



I wonder at what point this will overflow?

md0 : active raid1 sdb1[2] sda1[0]
      128384 blocks [2/1] [U_]
      [>....................]  recovery =  0.0% (0/128384) 
finish=198160.7min speed=0K/sec

:-)

-Rob


On Thu, 10 Apr 2003, Chuck Ebbert wrote:

quoted

md0 : active raid1 sdb1[2] sda1[0]
    128384 blocks [2/1] [U_]
     [>....................]  recovery =  0.0% (0/128384) 
finish=3658.9min speed=0K/sec

 What does it say in your syslog about this?


--
 Chuck
 I am not a number!
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html