Promise SX6000 question.

Hi,

I am using a Promise SX6000 RAID controller and five Seagate 120GB drives to
create a 480GB RAID-5 array, to be used under Slackware v8.1. I was able to
compile and load the Promise pti_st.o module, and subsequently was able to
create a single new large partition on the /dev/sda1 drive, as follows:

Disk /dev/sda1: 64 heads, 32 sectors, 457758 cylinders
Units = cylinders of 2048 * 512 bytes

     Device Boot    Start       End    Blocks   Id  System
/dev/sda1p1             1    457758 468744176   83  Linux


The problem is I cannot seem to create a file system on this new partition. I
was assuming that ext3 would be a good initial  choice, at least while we were
fooling around using this new array.

Any thoughts about what I might be doing wrong, or what I might be missing?

	Thanks,
		Seth Hall
		Speech Comm. Group
		MIT, Cambridge