Re: (no subject)

Eddie Johnson wrote:

I installed Suse Linux Professional 8 on a HP Netserver LC3 PII/450.  An
AHA-2940 UW Scsi host adapter with a AIC-78XX Scsi Protocol Chip/50 pin
high density scsi-2 control.  I have a raid (3 drives) off the host

No, you have an HP NetRaid Adapter (Aka AMI megaraid)

adapter and a 80 gig scsi drive off the mother board. After launching
yast2 the first raid has the following device: LD0 raid 5 34730R:
device_name /dev/sda, vendor megaraid.  Disk two (80 gig drive) has LD1
raid 0 70006R: device name /dev/sdb vendor the same as above.  There was
no raidtab file so I created one with the following: >

.........

If I read this correctly both are inactive when it should be stating
that they are active.  At this point I am baffled any suggestions or
possible directions would greatly be appreciated.

you don't need md, mkraid or such,
if you want to configure your hw raid just press Ctrl-M at boot
or start the server from the Navigator CD

L.