On most X86/ACPI devices there is no devicetree to supply the necessary
init-data. Instead the firmware already fully initializes the bq25890
charger at boot. To support this, add support for reading back the
settings from the chip through a new "linux,read-back-settings" boolean.

So far this new property is only used on X86/ACPI (non devicetree) devs,
IOW it is not used in actual devicetree files. The devicetree-bindings
maintainers have requested properties like these to not be added to the
devicetree-bindings, so the new property is deliberately not added
to the existing devicetree-bindings.

Signed-off-by: Hans de Goede <redacted>
---
Changes in v2:
- New patch in v2 of this series, together with the "linux,skip-reset" patch
  this patch replaces the "ti,skip-init" patch from v1
---
 drivers/power/supply/bq25890_charger.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/power/supply/bq25890_charger.c b/drivers/power/supply/bq25890_charger.c
index 864904d7eaeb..b7c38d2c5ede 100644
--- a/drivers/power/supply/bq25890_charger.c
+++ b/drivers/power/supply/bq25890_charger.c

@@ -111,6 +111,7 @@ struct bq25890_device {
 	struct regmap_field *rmap_fields[F_MAX_FIELDS];
 
 	bool skip_reset;
+	bool read_back_init_data;
 	enum bq25890_chip_version chip_version;
 	struct bq25890_init_data init_data;
 	struct bq25890_state state;

@@ -666,7 +667,7 @@ static int bq25890_chip_reset(struct bq25890_device *bq)
 
 static int bq25890_rw_init_data(struct bq25890_device *bq)
 {
-	bool write = true;
+	bool write = !bq->read_back_init_data;
 	int ret;
 	int i;
 

@@ -950,6 +951,10 @@ static int bq25890_fw_probe(struct bq25890_device *bq)
 	struct bq25890_init_data *init = &bq->init_data;
 
 	bq->skip_reset = device_property_read_bool(bq->dev, "linux,skip-reset");
+	bq->read_back_init_data = device_property_read_bool(bq->dev,
+						"linux,read-back-settings");
+	if (bq->read_back_init_data)
+		return 0;
 
 	ret = bq25890_fw_read_u32_props(bq);
 	if (ret < 0)

-- 
2.31.1