Re: [PATCH 1/2] power: supply: max17042_battery: Clear status bits in interrupt handler

On poniedziałek, 13 września 2021 15:02:34 CEST Krzysztof Kozlowski wrote:

On 12/09/2021 22:54, Sebastian Krzyszkowiak wrote:

quoted

The gauge requires us to clear the status bits manually for some alerts
to be properly dismissed. Previously the IRQ was configured to react only
on falling edge, which wasn't technically correct (the ALRT line is active
low), but it had a happy side-effect of preventing interrupt storms
on uncleared alerts from happening.

Fixes: 7fbf6b731bca ("power: supply: max17042: Do not enforce (incorrect)
interrupt trigger type") Cc: [off-list ref]
Signed-off-by: Sebastian Krzyszkowiak <sebastian.krzyszkowiak@puri.sm>
---

 drivers/power/supply/max17042_battery.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/power/supply/max17042_battery.c

b/drivers/power/supply/max17042_battery.c index
8dffae76b6a3..c53980c8432a 100644

--- a/drivers/power/supply/max17042_battery.c
+++ b/drivers/power/supply/max17042_battery.c

@@ -876,6 +876,9 @@ static irqreturn_t max17042_thread_handler(int id,

void *dev)> 
 		max17042_set_soc_threshold(chip, 1);
 	
 	}

+	regmap_clear_bits(chip->regmap, MAX17042_STATUS,
+			  0xFFFF & ~(STATUS_POR_BIT | 

STATUS_BST_BIT));

quoted

+

Are you sure that this was the reason of interrupt storm? Not incorrect
SoC value (read from register for ModelGauge m3 while not configuring
fuel gauge model).

Yes, I am sure. I have observed this on a fully configured max17055 with 
ModelGauge m5. It also makes sense to me based on what I read in the code and 
datasheets.

There were two kinds of storms - the short ones happening on each SOC change 
caused by SOC threshold alerts set by max17042_set_soc_threshold which 
eventually got cleared by reconfiguring the thresholds; and a huge one 
happening when SOC got down to 0% that did not get away until the battery got 
charged to at least 1% at which point the thresholds got reconfigured again 
(which is how I noticed the underflow fixed by the second patch).

Besides, I also have patches for configuring m5 gauge via DT that I'll send 
once I clean them up.

You should only clear bits which you are awaken for... Have in mind that
in DT-configuration the fuel gauge is most likely broken by missing
configuration. With alert enabled, several other config fields should be
cleared.

I have checked all the bits in the Status register and aside of Bst, POR and 
bunch of "don't-care" bits they're all alert indicators that we either handle 
explicitly in the interrupt handler (Smn/Smx) or implicitly via 
power_supply_changed (Imn/Imx, Vmn/Vmx, Tmn/Tmx, dSOCi, Bi/Br). The driver 
unconditionally enables alerts for SOC thresholds and all the rest stays 
effectively disabled at POR; however, a bootloader or firmware may configure it 
differently, which may be wanted for things like resuming from suspend when a 
bad condition happens. Therefore we need to clear all the bits anyway and I'm 
not sure whether iterating through them in a "if set then clear" loop gains us 
anything aside of additional lines of code.

Best regards,
Krzysztof

Cheers,
Sebastian