Re: [PATCH v5 2/4] Documentation: dt: add bindings for ti-cpufreq

On 02/08/2017 06:02 PM, Rafael J. Wysocki wrote:

On Wednesday, February 08, 2017 08:45:55 AM Dave Gerlach wrote:

quoted

On 02/08/2017 08:44 AM, Rob Herring wrote:

quoted

On Fri, Feb 3, 2017 at 11:29 AM, Dave Gerlach [off-list ref] wrote:

quoted

Add the device tree bindings document for the TI CPUFreq/OPP driver
on AM33xx, AM43xx, DRA7xx, and AM57xx SoCs. The operating-points-v2
binding allows us to provide an opp-supported-hw property for each OPP
to define when it is available. This driver is responsible for reading
and parsing registers to determine which OPPs can be selectively enabled
based on the specific SoC in use by matching against the opp-supported-hw
data.

Acked-by: Viresh Kumar <viresh.kumar@linaro.org>
Signed-off-by: Dave Gerlach <redacted>
---

[...]

quoted

+/*
+ * cpu0 has different OPPs depending on SoC revision and some on revisions
+ * 0x2 and 0x4 have eFuse bits that indicate if they are available or not
+ */
+cpu0_opp_table: opp_table {

One step closer, but as I showed last time, use a '-', not '_'.

I apologize I thought the comment was only about the 0, completely missed the
underscore, you are correct, thanks.

Please send an update of this patch, then.

Yes, sent an update of just this patch in reply to the original patch email, thanks.

Regards,
Dave

Thanks,
Rafael