[PATCH v3 0/6] BQ24190 charger fixes

These are misc fixes, tested on a custom OMAP3 board.

Changes in v3

#1 fixes figure ID to 37
#5 fixes line over 80 chars
#* adds Acked-by Tony & Mark

Changes in v2

#1 reorders:            Fix irq triggering to IRQF_TRIGGER_FALLING
#2 factors out part of: Call power_supply_changed() only for relevant component
#3 replaces:            Call enable_irq() only at the end of probe()
#4 reorders:            Call power_supply_changed() only for relevant component
#5 unscrambles:         Don't read fault register outside irq_handle_thread()
#6 factors out part of: Don't read fault register outside irq_handle_thread()

These are dropped; Tony will resubmit them in new patchset:
  Check the interrupt status on resume
  Use PM runtime autosuspend

Initial patchset v1

Mark, I missed Tony's 0/6 preamble last time. It was...

Liam Breck (4):
  power: bq24190_charger: Call enable_irq() only at the end of probe()
  power: bq24190_charger: Fix irq triggering to IRQF_TRIGGER_FALLING
  power: bq24190_charger: Call power_supply_changed() only for
relevant component
  power: bq24190_charger: Don't read fault register outside irq_handle_thread()

Tony Lindgren (2):
  power: bq24190_charger: Check the interrupt status on resume
  power: bq24190_charger: Use PM runtime autosuspend