Re: [PATCH v2 3/6] PowerCap: Added to drivers build

From
Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
Date
2013-10-04 19:38:48
Also in
lkml
Reply to
Gene Heskett, 2013-10-04
On 10/04/2013 12:24 PM, Gene Heskett wrote:
On Friday 04 October 2013, Srinivas Pandruvada wrote:
quoted
Added changes to Makefile and Kconfig to include in driver build.

Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
Signed-off-by: Jacob Pan <redacted>
Acked-by: Rafael J. Wysocki <redacted>
---
drivers/Kconfig  | 2 ++
drivers/Makefile | 1 +
2 files changed, 3 insertions(+)
diff --git a/drivers/Kconfig b/drivers/Kconfig
index aa43b91..969e987 100644
--- a/drivers/Kconfig
+++ b/drivers/Kconfig
@@ -166,4 +166,6 @@ source "drivers/reset/Kconfig"
source "drivers/fmc/Kconfig"

+source "drivers/powercap/Kconfig"
+
endmenu
diff --git a/drivers/Makefile b/drivers/Makefile
index ab93de8..34c1d55 100644
--- a/drivers/Makefile
+++ b/drivers/Makefile
@@ -152,3 +152,4 @@ obj-$(CONFIG_VME_BUS)		+= vme/
obj-$(CONFIG_IPACK_BUS)		+= ipack/
obj-$(CONFIG_NTB)		+= ntb/
obj-$(CONFIG_FMC)		+= fmc/
+obj-$(CONFIG_POWERCAP)		+= powercap/
I would object to this whole premise if it is not under the absolute
control of the users program. Linuxcnc for instance is intimately married
to a parport whose status for writes is absolutely stable from write to
write, and whose status may be in some cases, read at sub 20 u-second
intervals.  Anything which would imped this, puts the operator of a 50+ ton
piece of machinery's life in jeopardy because its status is not readable in
as close to real time as possible as it may be required to initiate a stop
from some alarm condition before it has moved far enough to injure, maim or
kill. 50 thousandths of an inch in further movement while moving a 70 ton
milling machines table at 150 inches a minute is not an unreasonable
expectation for us.
<Sorry, I didn't understand. Are you pointing any problem in this patch or patch-set in general?
This change added powercap directory to the kernel build. Is something wrong with it or any other way to do that?
Cheers, Gene
Thread (15 messages) 15 messages, 5 authors, last reply 2013-10-04
Keyboard shortcuts
hback out one level
jnext message in thread / next series-diff position
kprevious message in thread / previous series-diff position
ldrill in
Escclose help / fold thread tree
?toggle this help