[PATCH 04/40] dt-bindings: mmc: Add Tegra SDHCI sampling trimmer values
From: Aapo Vienamo <hidden>
Date: 2018-08-01 16:37:19
Also in:
linux-devicetree, linux-tegra, lkml
Subsystem:
multimedia card (mmc), secure digital (sd) and sdio subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Ulf Hansson, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Document the Tegra SDHCI inbound and outbound sampling trimmer values. Signed-off-by: Aapo Vienamo <redacted> --- .../devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt | 11 +++++++++++ 1 file changed, 11 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
index 2e973b5..3c7960a 100644
--- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
+++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt@@ -68,6 +68,10 @@ Optional properties for Tegra210 and Tegra186: - nvidia,pad-autocal-pull-up-offset-hs400, nvidia,pad-autocal-pull-down-offset-hs400 : Specify drive strength calibration offsets for HS400 mode. +- nvidia,default-tap : Specify the default inbound sampling clock + trimmer value for non-tunable modes. +- nvidia,default-trim : Specify the default outbound clock trimmer + value. Notes on the pad calibration pull up and pulldown offset values: - The property values are drive codes which are programmed into the
@@ -78,6 +82,13 @@ Optional properties for Tegra210 and Tegra186: - The SDR104 and HS400 timing specific values are used in corresponding modes if specified. + Notes on tap and trim values: + - The values are used for compensating trace length differences + by adjusting the sampling point. + - The values are programmed to the Vendor Clock Control Register. + Please refer to the reference manual of the SoC for correct + values. + Example: sdhci@700b0000 { compatible = "nvidia,tegra210-sdhci", "nvidia,tegra124-sdhci";
--
2.7.4